Giveaway of the Day Forums » General discussion

1. petelynch
   Member

   It installed correctly and ran straight after installation. When it ran it claimed
   to be unable to deal with my hard disk model. At that point I pretty much gave up
   (first impressions 'n' all).
   While preparing to post to the forum about what a load of ?*&% it was, I ran it again.
   This time it did recognise my drive (ST9120821A, 120GB 2.5") and reported correctly.
   I wonder how many other people will have it fail at startup and therefore never run
   it again - even if it would eventually work?

   Looks like it needs a little work to have it start correctly after an install.

   Posted 1 year ago #

2. Lee
   Moderator

   Did you install it on a notebook or laptop?

   Posted 1 year ago # | Login to Send PM

3. alexiussg
   Member

   no, for me, the prog doesn't display anything when i launch it until i plugged out my card reader. y? from the task manager, i can see tt it is running, but it doesn't display until i removed my card reader.

   Posted 1 year ago #

4. playboy85
   Member

   I have installed and uninstalled three times. Each time the program shows it couldn't find a hard drive. There is no way to try to locate the hard drive within the program and the help section (both within the program and online) had no mention of what to do in this situation. Useless.

   Posted 1 year ago #

RSS feed for this topic

Reply

You must log in to post.